Ticket #2435 (closed defect: fixed)

Opened 13 years ago

Last modified 13 years ago

Viewer: cannot go to the specified offset

Reported by: andrew_b Owned by: andrew_b
Priority: minor Milestone: 4.7.5
Component: mcview Version: master
Keywords: Cc:
Blocked By: Blocking:
Branch state: Votes for changeset: committed-master

Description

Viewer Goto dialog doesn't allow go to the specified offset. The value of input line is rounded to the next nearest line start. Such bevaviour is useless in hex editor mode of viewer. In hex mode we must heve a capability to go to the specified address as is without any round.

Change History

comment:1 Changed 13 years ago by andrew_b

  • Priority changed from major to minor
  • Owner set to andrew_b
  • Status changed from new to accepted
  • severity changed from no branch to on review

Created 2435_viewer_goto branch. Parent branch is master.
changeset:3c50218c9ce5cfdc9e76f42f3790baad6acfacdf

comment:2 Changed 13 years ago by slavazanko

  • Votes for changeset set to slavazanko

comment:3 Changed 13 years ago by angel_il

  • Votes for changeset changed from slavazanko to slavazanko angel_il
  • severity changed from on review to approved

comment:4 Changed 13 years ago by andrew_b

  • Status changed from accepted to testing
  • Votes for changeset changed from slavazanko angel_il to committed-master
  • Resolution set to fixed
  • severity changed from approved to merged

comment:5 Changed 13 years ago by andrew_b

  • Status changed from testing to closed
Note: See TracTickets for help on using tickets.